您好,歡迎來到營口波海菱鎂材料有限公司官網!
輕燒鎂球

新聞分類

產品分類

聯系我們

營口波海菱鎂材料有限公司          

聯系人:莊 延 山(先生)

地 址:大石橋市南樓經濟開發區高莊村

電 話:0417-5289488  13904074678

郵 箱:dsqbohai@126.com

郵 編:115100

 

Yingkou Bohai Magnesium Materials Co., Ltd.

Contact: Zhuang Yanshan (Mr.)

Location: Gaozhuang Village, Nanlou Economic Development Zone, Dashiqiao City

Phone call: +86 0417-5289488  +86 13904074678

Mailbox: dsqbohai@126.com 

Zip code: 115100

輕燒鎂粉簡述 Brief Introduction of Light Burned Magnesium Powder

您的當前位置: 首 頁 >> 新聞資訊 >> 技術中心 Technology Center

輕燒鎂粉簡述 Brief Introduction of Light Burned Magnesium Powder

發布日期:2016-05-15 00:00 來源:http://www.xaqinyun.com 點擊:

輕燒鎂粉

輕燒鎂粉按化學成分分為 :QM-96、QM-95、QM-94、QM-92、QM-90、QM-87、QM-85、QM-80、QM-75 九種牌號。

試驗方法

 化學分析方法按 GB 5069 進行。
 粒度測定用國際標準篩檢驗,即 120 目和 100 目分別用孔徑 0.125mm 和 0.15mm 的國際標準篩檢驗。

檢驗規則

 成品每批的重量不大于 120 t 。
 測定粒度的樣品應在組批前進行采樣,化學分析的樣品應在組批后進行采樣。小袋 (25kg) 每 20 袋取一個份樣,每個大袋 (1000kg)取一個份樣。
將取得的粒度樣品充分混勻后,點取 10~20g 測定粒度?;靹蚝蟮幕灅悠房s分為 200g 送化驗室進行分析。

檢驗結果如有某項化學成分不合格或異常,則在同一批產品批量中重新取雙倍數量的樣品進行復驗一次,以復驗結果為該批產品的最終檢驗結果。


Lightly burned magnesium powder is divided into nine grades: QM-96, QM-95, QM-94, QM-92, QM-90, QM-87, QM-85, QM-80, QM-75 according to chemical composition.

experiment method

The chemical analysis method was carried out according to GB 5069.

The particle size is measured by the international standard sieve, that is, 120 mesh and 100 mesh are tested by the international standard sieve with the pore size of 0.125mm and 0.15mm, respectively.

testing regulations

The weight of each batch of the finished product is not more than 120 t.

Samples for determination of particle size should be sampled before the batch, and samples for chemical analysis should be sampled after the batch. Small bags (25kg) take one sample every 20 bags and one large bag (1000kg) take one sample.

After the obtained particle size sample is thoroughly mixed, 10 to 20 g is taken to determine the particle size. The mixed test sample is divided into 200g and sent to the laboratory for analysis.

If there is any chemical composition that is unqualified or abnormal in the test results, double the number of samples in the same batch of product for re-inspection once, and the re-inspection result is the final inspection result of the batch of products.


相關標簽:輕燒鎂粉

在線客服
分享
歡迎給我們留言
請在此輸入留言內容,我們會盡快與您聯系。
姓名
聯系人
電話
座機/手機號碼